Single 18650 Battery Holder


Home Products History Buy Contact


With regret, Turboferret Industries has ceased production due to personal reasons. Once stocks have run out, trading will stop completely. Please note stock levels for individual parts on the buy page when ordering. These will be updated daily, but may not be totally up to date, so adjustments may be required subsequent to your purchase. Many thanks for all of the support over the past year.

Holders are no longer available soldered. All parts will be delivered assembled, and instructions for wiring to give the appropriate configurations will be available. Kits will be available in component form only, not fully assembled.



Cast in polyurethane resin and using commercial spring battery clips.

No wires, simply battery clips to solder as you wish 8

This holder is designed to be used only with protected cells as there is no additional protection circuitry built in.

Dimensions
Without batteries - 88 x 26mm, 16g
With batteries - 88 x 26mm, 65g

Also available in quad cell and twin cell size with matching pouches.

Quality
Please be aware that these are not mass-produced injection moulded items, they are hand cast in small numbers by hand using silicon moulds. Although the quality of the holders is good, please expect the odd small air bubble due to the moulding process. If this puts you off, you should look elsewhere.

Lead Time
Turboferret is now based in Italy for 3 weeks a month, but returning to the UK once a month. Production continues, but despatch will be on a monthly basis from the UK, lead time will therefore be typically 3 weeks, but should never be any more than 1 month. Contact me to find out when I will next be shipping orders.