Holders are no longer available soldered. All parts will be delivered assembled, and instructions for wiring to give the appropriate configurations
will be available. Kits will be available in component form only, not fully assembled.
Cast in polyurethane resin and using commercial spring battery clips.
This holder is designed to be used only with protected cells
as there is no
additional protection circuitry built in.
Without batteries - 88 x 40mm, 36g
With batteries - 88 x 40mm, 181g
Also available in quad, twin
and single cell
size with matching pouches
Please be aware that these are not mass-produced injection moulded items, they are
hand cast in small numbers by hand using silicon moulds. Although the quality of the holders
is good, please expect the odd small air bubble due to the moulding process. If this puts
you off, you should look elsewhere.
Turboferret is now based in Italy for 3 weeks a month, but returning to the UK once a month.
Production continues, but despatch will be on a monthly basis from the UK, lead time will therefore be typically 3 weeks, but should never be any more than 1 month.
Contact me to find out when I will next be shipping orders.